Where To Fit A Distribution Board?

- Jul 06, 2020-

Where To Fit A Distribution Board

WHERE TO FIT A DISTRIBUTION BORAD

  

An often overlooked element of fitting a Distribution Board is the location where it is placed. Distribution Boards are famously located in some of the most awkward places imaginable often behind piles of storage boxes, in the darkest corner at floor level! Many of these may well have been fitted before the days of regulations and on replacement will need to be situated in the correct location.


Location

When choosing where to place the Distribution Board, thought needs to be given to how the Distribution Board will be accessed. Distribution Board locations are notorious for being in the most awkward of places. It is important that it is easy to reach the Distribution Board and there is sufficient space around the Distribution Board to operate switches and protective devices such as RCDs. It must also be easily accessible for an electrician to access the Distribution Board to enable them to carry out inspections and maintenance which may require the electrician to access all connections to the Distribution Board. Space is therefore essential! Unsuitable Distribution Board locations include enclosures, compartments or other confined spaces.


Distribution Board switches and protective devices within a Distribution Board need to be easily accessible to the householder. Access which would require the use of a ladder or similar reaching platform would not be suitable. Thought needs to be given to the needs of the householder particularly if they are disabled, elderly or infirm. In these cases, access to switches and protective devices should comply with BS 8300 – Design of buildings and their approaches to meet the needs of disabled people.

 

Mounting Height

The Part M of the building regulations for England and Wales requires reasonable provision to be made for people to gain access and to use the building and its facilities. Guidance on meeting the requirements is given in Approved Document M. Particular attention needs to be given to Section 8 of approved document M as this includes the objective of assisting people whose reach is limited to use their home more easily by locating wall mounted switches and socket outlets no higher than 1.2m and not lower than 0.45m above finished floor level.


Whilst Approved Document M does not recommend a height for new Distribution Boards, the 2013 version of Approved Document P points out that one way of complying with Part M in new dwellings is to mount Distribution Boards so that the switches are between 1350mm and 1450mm above floor level. At this height, the consumer unit is out of reach of young children yet accessible to other people when standing or sitting.


Although this would only apply to new buildings, it is worth giving thought to the mounting height on the Distribution Board to so that the Distribution Board is out of reach of young children yet accessible to other people when standing or sitting.


When taking all these principles and building regulations into account it comes as no surprise that relocating a consumer unit is work that must be carried out by a Part P Registered electrician who are there to ensure your safety and well being.


Welcome to enjoy JUNON distritbution board.